Will this bumper work with my factory fog light cutouts?

The R34 profile features integrated duct vents in place of traditional round fog holes. Verify your existing fog assembly location against the bumper's vent positioning before final installation. You may need to relocate or adapt your fog housing to match the new bumper design.

Do I need to modify my lower valance or air dam?

The R34 bumper sits lower than stock and extends further forward. Check clearance between the new bumper lip and any existing lower valance, splitter, or undertray before securing. Minor trimming of the factory air dam may be necessary depending on your specific setup.

Should I sand and prime this before painting?

Yes. Sand the surface with appropriate grit to promote adhesion, then apply your chosen primer and finish coat system. Proper surface prep ensures paint durability and prevents peeling or adhesion failure over time.