Will this bumper align with my OEM fog lights and sensor holes?

Before installation, verify the location of your vehicle's OEM fog light cutouts and any parking sensors on the original bumper. The Colt V2 profile may require minor trimming or repositioning of existing openings to match your specific setup. Test-fit the panel dry and mark any cutout locations before final mounting.

Can I install this without modifying my exhaust?

Exhaust positioning varies by muffler type and tip design. Verify clearance between your current exhaust tip and the new bumper panel before committing to fasteners. If your exhaust sits close to the rear edge, you may need to adjust or reposition the tip slightly for clean fitment.

What should I use to prep the surface before painting?

Sand the surface lightly to improve paint adhesion, then wipe clean of dust. Apply your chosen primer and paint system following the product instructions. FRP responds well to standard automotive paint once properly prepped—no special primers or sealers required beyond your normal prep routine.